EGO POWER+ ZT5200E-L Manual page 76

NOTICE: If a fault code appears on LCD screen, remove all battery packs and re-insert them a few minutes later. If
this doesn't solve the problem, follow the fault code troubleshooting below.
LCD
Description
Display
PCBA controlled
right driving
motor fails.
Plug (Triple-
phase, power
wire) connecting
the right driving
motor with the
corresponding
Right
PCBA is
See driving
loosened.
"Fault motor
Code"
fails in
Plug (Six pins,
rotation.
signal wire)
connecting the
right driving
motor with the
corresponding
PCBA is
loosened.
Right driving
motor fails.
PCBA controlled
left blade motor
fails.
Plug (Triple-
phase, power
Left
wire) connecting
See blade
the left driving
"Fault motor
motor with the
Code" fails in
corresponding
rotation.
PCBA is
loosened.
Left blade motor
fails
Fault
Mower
Code
Status Beeper
on
Indicator
LCD
313 OFF One beep
417 OFF One beep
401 OFF One beep
417 OFF One beep
607/
n/a One beep
A07
509 n/a One beep
509 n/a One beep
Cause Solution
PCBA failure
Loose connection
Have repairs performed
by a qualified service
technician.
Loose connection
Motor failure
Have repairs performed
PCBA failure by a qualified service
technician.
Inspect the blade
firstly. If it is loosened,
tighten the bolt with
Loose connection
recommended torque
Otherwise, have
repairs performed by
a qualified service
technician.
Motor failure
ZERO TURN RIDE-ON MOWER — ZT5200E-L
EN
41