Table of Contents
Advertisement
Available languages
Available languages
PROBLEM
CAUSE
◾
When the mower is turned
off on ground without
removing the battery pack(s)
from the mower, the battery
indicators, start/stop button
and set button will remain
illuminated for a period.
The battery indicators
◾
When the mower is turned
are still on when the
off on a slope without setting
mower is turned off.
the parking brake pedal at
the braking position, the
battery indicators will keep
on until the battery charge
is depleted. The beeping
indicator keeps sounding at
the same time.
◾
The LCD screen fails to
The pressing time on the
be illuminated with all
start/stop button is not
icons on.
sufficient.
◾
The blades are dull.
The mower cuts
◾
The blades are bent.
unevenly, with
significant height
difference front to rear.
◾
The mower deck is not
leveled, resulting in different
cutting blade height.
◾
The mower deck nuts are
The actual grass
loosened on the suspension
cutting height is
linkage
not aligned with the
◾
claimed height.
The mower deck is damaged
or seriously worn.
◾
Wet grass clippings are
sticking to the underside of
The mower does not
the deck.
mulch properly.
◾
The mower is set to cut too
much grass at once.
SOLUTION
◾
No action is needed. The battery indicators will go off
when the mower shuts off after a period. Refer to the
section "STOPPING THE MOWER" for specific time.
◾
Set the parking brake pedal in the braking position
before the operator leave the tool on the slope.
◾
The LCD screen will only display "Fuel Gauge" when
the start/stop button is pressed briefly.
◾
The LCD screen will turn on after the start/stop
button has been pressed for sufficient time.
◾
Sharpen or replace the cutting blade as instructed in
this manual.
◾
Replace the bent cutting blade following the
instructions in section "REPLACING THE CUTTING
BLADES".
◾
Level the mower deck following the instructions in
section "LEVELING THE MOWER DECK".
◾
Follow the instructions in section "LEVELING THE
MOWER DECK" to make correct front-to-rear
adjustment for the mower deck and securely tighten
the nuts on the suspension linkage.
◾
Follow the instructions in section "REMOVING THE
MOWER DECK" to have mower deck replacement.
◾
Wait until the grass dries before mowing.
◾
Raise the deck cutting height.
ZERO TURN RIDE-ON MOWER — ZT5200E-L
EN
33
Advertisement
Table of Contents
