Table of Contents
Advertisement
Erase all RF Remote Fobs from the PIR
All manuals and user guides at all-guides.com
Light Controller
• Press and hold the centre button, located on the
Installing a RF Remote Fob into a Wall Switch
• Remove the rubber caps from
15
• Using 2 of the wires supplied,
bottom of the PIR light controller, for approximately
5 seconds. The lamp will flash 5 times.
This indicates that un-pairing has been successful.
the bottom of the fob as shown.
push them firmly into the
2 spring clamp terminals.
Check they are both secure
with a light tug.
Remove
rubber caps
Advertisement
Table of Contents
Need help?
Do you have a question about the SLB2300RF and is the answer not in the manual?