Timeguard SLB2300RF Installation & Operating Instructions Manual page 15

All manuals and user guides at all-guides.com
• Press the fob button once.
14
• After the last fob press, wait for approximately
• Test your fob(s) by pressing the fob button once to
Note: once the lamp has flashed twice, the PIR
sensor will no longer trigger the lamp with motion
until the pairing sequence has been completed.
The lamp will turn ON
for 3 seconds, and back
OFF again, to indicate
it has been registered.
Note: If you have more than one fob to pair
(Up to 6 max) then press the fob buttons, one at a
time, waiting for the lamp to turn ON for 3 seconds
and back OFF again each time, between presses.
You cannot pair a 7th fob. If attempted, the lamp
will flash twice to indicate it has not been paired.
30 seconds until the lamp flashes twice.
This will indicate that your fob(s) have successfully
been paired.
Note: once the lamp has flashed twice, the PIR
light controller will begin to trigger with motion
once again.
turn the lamp ON, and once to turn the lamp OFF. If
you are using more than fobs, you are able to turn
the lamp ON using one fob, and turn the lamp OFF
using another.