Timeguard SLB2300RF Installation & Operating Instructions Manual page 11

• The lamp will illuminate for approximately 35
All manuals and user guides at all-guides.com
• If the detection area is too small for you
Setting Up for Automatic Operation
(Auto Mode)
• When walk tests are complete, the unit can be set
10
• The DELAY TIME ADJUST setting controls how long
• The minimum time (fully anti-clockwise) is approx.
• Set the control to the desired setting between
• The DUSK LEVEL ADJUST control determines the
seconds. This indicates the unit is wired correctly.
The unit is in Test Mode when the light turns OFF.
requirements, try angling the PIR light controller
head up. This will increase the detection area.
Angling the head downwards will reduce the
detection area should a smaller coverage be
required.
into Auto Mode.
the unit remains illuminated following activation
and after all motion ceases.
3 seconds, whilst the maximum time (fully
clockwise) is approximately 18 minutes.
these limits.
level of darkness required for the unit to start
operating. The DUSK adjustment knob is indicated
by the 'Moon' and 'Sun' symbols).