Timeguard SLB2300RF Installation & Operating Instructions Manual page 14

10.2 The terminals are now accessible. If adding
All manuals and user guides at all-guides.com
10.3 Re-attach the PIR light controller to the back plate
11. RF Remote Fob
Battery
• To access the battery holder,
13
Pairing the RF Remote Fob(s) with the PIR
Light Controller
• Press the centre button that
lighting, ensure the unit's maximum switching load
rating is not exceeded (see section 3. Technical
Specifications).
pushing firmly into place.
remove the back plate from
the fob as shown in
the diagram.
Note: You must complete the Walk Test Procedure
before you can pair the devices. The pairing of the
fob(s) cannot be actioned with the PIR light controller
set to Test Mode. Make sure the PIR light controller is
functioning correctly and set for Automatic Operation
(Auto Mode) before you continue.
is located on the bottom
of the PIR light controller once
(do not press and hold for
longer than 4 seconds), the
lamp will flash twice to indicate
it is ready to pair your fob(s).