Mst - TRENDnet PoE Web Smart Switch Series User Manual

TRENDnet User's Guide

P2P: Choosing the Forcetrue parameter indicates a point-to-point (P2P) shared
link. P2P ports are similar to edge ports however they are restricted in that a
P2P port must operate in full-duplex.
Like edge ports, P2P ports transition to a forwarding state rapidly thus
benefiting from RSTP. A P2P value of Forcefalse indicates that the port cannot
have P2P status. Auto allows the port to have P2P status whenever possible
and operate as if the P2P status were true. If the port cannot maintain this
status, (for example if the port is forced to half-duplex operation) the P2P
status changes to operate as if the P2P value were Forcefalse.
The default setting for this parameter is Auto.

Restricted Role: Toggle between True and False to set the restricted role state
of the packet. If set to True, the port will never be selected to be the Root port.
The default value is False.

Restricted TCN: Toggle between True and False to set the restricted TCN of the
packet. Topology Change Notification (TCN) is a BPDU that a bridge sends out
to its root port to signal a topology change. If set to True, it stops the port from
propagating received TCN and to other ports. The default value is False.

Migrate: Indicates if the port is configured to accept RSTP and STP BPDUs.
4. At the bottom of the left hand panel, click Save.
5. Select the Config you would like to save the settings to, click Save Settings to Flash,
then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
© Copyright 2018 TRENDnet. All Rights Reserved.

MST

Network > Spanning Tree > MST
1. Log into your switch management page (see
on page 5).
2. Click on System, click on Spanning Tree, and click on MST.
3. Review the settings. For each section, click Apply to save changes.
MST Configuration Identification Settings

Configuration Name: A configured name set on the switch to uniquely identify
the MSTI (Multiple Spanning Tree Instance). If a configuration name is not set,
this field shows the MAC address of the device running MSTP.

Revision Level (0-65535): This value, together with the configuration name,
and identical vlans mapped for STP instance IDs identifies the MST region
configured on the switch.
MST Instance Settings

MSTI ID (1 - 31): Displays the MSTI ID associated with the VID List. The possible
field range is 1-31.

VID List (1 - 4094): Displays the VID List. Click Add to add into MST Table below.

Priority: Enter the new priority in the Priority field. The user may set a priority
value between 0-61440.
PoE Web Smart Switch Series
"Access your switch management page"
43