Table of Contents
Advertisement
POST INSTALLATION TEST
FCCS Network Connection Test
Make sure that the LYR LED flashes at 60-INT.
Remains ON
when available
for Ethernet
Note:
When the FCH is a "Root Bridge", the LOAD LED remains ON.
STEP 4: Return Mode to 8 (standard setting) when the test is complete.
STEP 5: Initialize the FCH (PA-FCHA) card using the MB switch.
Be sure to initialize the FCH (PA-FCHA) card, after changing the setting of the Mode Switch.
Note:
3. FCCS Network Connection Test
This section explains how to perform the following connection tests within the Fusion network:
•
Station-to-Station Connection Test (via FCCS)
•
ATTCON Connection Test (via FCCS)
•
Line (LC, ELC, DLC card) Connection Test (via FCCS)
•
3-party Conference Trunk Function Test (via FCCS)
3.1 Station-to-Station Connection Test (via FCCS)
Perform the station-to-station connection test, following the procedure listed below.
3.1.1
FCCS Call Origination Test
STEP 1: Using the MBCT command, make busy all trunks in the route except the trunk to be tested.
STEP 2: Lift the handset of STN A in Node A.
STEP 3: Dial a Telephone Number (STN B) which belongs to another node.
CHAPTER 6
Page 138
Revision 3.0
When the result of test
is OK, the LYR LED
flashes.
LYR
Flash
LB
LOAD
Remains ON
when ready to broadcast
Front View
data packets
Note
Figure 6-7 Fusion Link-Test Results
ND-70185 (E)
Get other manuals https://www.bkmanuals.com
FCH (PA-FCHA) card
EST3
Send
Receive Polarity of
EST2
pair-wire is normal
EST1
Receive
EST0
Link is
established
MB
MNT
Mode
8
DTI
FCH
Front View
Check
Advertisement
Table of Contents
