Table of Contents
Advertisement
4. Data Programming
This section explains how to assign a brand-new EX-FCCS network data.
There are some conditions for data programming to be required for EX-FCCS.
1.
When connecting a stand-alone NEAX2400 IMX, non-fusion system (via EX-FCCS) or a NEAX2000
2
IVS
using Enhanced CCIS feature to an existing FUG:
(a) The system must be the NCN.
(b) The system is programmed as the Fusion Network configured by one NCN only.
(c) Use the NDM of the system to program the network data.
2.
When connecting the NEAX2400 IMX system and the NEAX2000 IVS
tion Code) =1 should always be assigned using ACIC2 command.
3.
ACSCL command data (CCH location per CSCG) must be programmed against the PC of the connected
NEAX2400 IMX or NEAX2000 IVS
2
system using ACIC1 command.
ND-70185 (E)
Get other manuals https://www.bkmanuals.com
EX- FCCS
Data Programming
2
system, CIC (Circuit Identifica-
CHAPTER 8
Page 185
Revision 3.0
Advertisement
Table of Contents
