Table of Contents
Advertisement
EX- FCCS
Data Programming
4.1 Brand-new EX-FCCS Network
To install EX-FCCS network as a brand-new system between two Fusion Groups (when no CCIS data has
been assigned), the overall data programming procedure is as follows.
[Example EX-FCCS Network]
FUG1(Center FUG)
NCN1
PC1
FPC1
FCCS
Centralized MAT
4.1.1
To Log in to All Nodes in EX-FCCS Network
Assign the following system data for all the nodes in the network. According to the condition of each
node, perform necessary data programming as follows.
<Node which accommodates CCIS Trunk (PC3 in the example)>
STEP 1: ASYD
Assign the Point Code for all the Nodes in the network uniquely. Since Point Code is used to identify each office
in the EX-FCCS network, any identical PCs are not allowed in the same network.
Originating Point Code (OPC) assigned by Indexes 180 and 181:
The OPC is a self-office code, which should be assigned without exception. 14 bits can be used for specifying
OPC. Note that available PC ranges from 1 to 16367 (PCs 16368~16383 are used for Loop Back Test). FPC3
in FUG1 whose OPC is 3, for example, should be assigned as follows.
Miscellaneous Data
Index 186:
b6 must be assigned as 1 (CCIS is in service). The remaining data should be determined depending on custom-
er's requirements.
CHAPTER 8
Page 186
Revision 3.0
FCCS
PC3
FCCS
FPC3
PC2
FPC2
b5
b4
b3
b2
b1
b0
0
0
0
0
0
0
Index 181
b7
b6
b5
b4
b3
0
1
0
1
0
ND-70185 (E)
Get other manuals https://www.bkmanuals.com
NCN2
EX-FCCS
PC4
FPC1
FCCS
b7
b6
b5
b4
b3
b2
0
0
0
0
0
0
Index 180
b2
b1
b0
Example (Index 186)
0
1
1
FUG2
FCCS
PC6
FPC3
FCCS
PC5
FPC2
b1
b0
PC 3
1
1
Advertisement
Table of Contents
