Table of Contents
Advertisement
Per 10/100Mbps port, PoE interfaces (Port-1 to Por-24)
LED
Color
LNK/ACT
Green
PoE In-Use
Orange
Per 10/100/1000Base-T port / SFP interfaces
LED
Color
1000
Green
LNK/ACT
10/100
Green
LNK/ACT
1.
Press the RESET button
2.
Press the RESET button for about
mode; the entire configuration will be erased.
3.
The 2 Gigabit TP/SFP combo ports are shared with port 25/26 of Managed Switch. Either of them can
operate at the same time.
To indicate the link through that port is successfully established.
Lights:
To indicate that the Switch is actively sending or receiving data over that port.
Blink:
To indicate the port is providing 52V DC in-line power.
Lights:
To indicate the connected device is not a PoE Powered Device (PD).
Off:
To indicate the link through that port is successfully established with speed
Lights:
1000Mbps.
To indicate that the Switch is actively sending or receiving data over that port.
Blink:
If 10/100 LNK/ACT LED is light, it indicates that the port is operating at 10Mbps or
Off:
100Mbps. If LNK/ACT LED is Off, it indicates that the port is link down.
To indicate the link through that port is successfully established with speed
Lights:
10Mbps or 100Mbps.
To indicate that the Switch is actively sending or receiving data over that port.
Blink:
If 1000 LNK/ACT LED is light, it indicates that the port is operating at 1000Mbps.
Off:
If 1000 LNK/ACT LED is Off, it indicates that the port is link down.
seconds. The Managed Switch will reboot automatically.
5
10
User's Manual of WGSW-2620HP
Function
Function
seconds. The Managed Switch will back to the factory default
18
Advertisement
Table of Contents
