Enerzone SOLUTION 3.5 INSERT Installation And Operation Manual page 47

9. Center the insert into the fireplace opening.
10. Align the notch in the faceplate extension with the bolt (R) welded to the air jacket located and
slide the faceplate assembly just over the bolt's head and washer (Q and P). Then push towards
the fireplace.
If necessary, adjust the height of the insert using the leveling bolts (S) on each side of
the convection air jacket until the faceplate is properly seated on the floor of the hearth
extension.
11. Once the faceplate is in place, secure the assembly by tightening nuts (P) using a 7/16" (11 mm)
open end wrench.
Installation and Operation Manual - Solution 3.5-I Page 47