Exhaust System - Enerzone SOLUTION 3.5 INSERT Installation And Operation Manual

3/32"
Using a flat screwdriver, turn the adjustable hinge rods in the direction shown to adjust the doors.
Using a flat screwdriver, turn the adjustable hinge rods in the direction shown to adjust the doors. Tighten
Tighten all door hinge pressure screws when they are at the desired positions. Configurations 1-2-3- all door hinge pressure screws when they are at the desired positions. Configurations 1-2-3-4-5-6, show
in which direction these act on the adjustment of the door
4-5-6, show in which direction these act on the adjustment of the door.
1
6.4

Exhaust System

Wood smoke can condense inside the chimney, forming a inflammable deposit called creosote.
If creosote builds up in the system, it can ignite when a hot fire is burned in the insert. A very
hot fire can progress to the top of the chimney. Severe chimney fires can damage even the best
chimneys. Smouldering, smoky fires can quickly cause a thick layer of creosote to form. When
the insert is operated properly, the exhaust from the chimney is mostly clear and creosote builds
up more slowly.
«Creosote - Formation and Need to Removal
When wood is burned slowly, it produces tar and other organic vapors, which combine with
expelled moisture to form creosote. The creosote vapors condense in the relatively cooler
chimney flue of a slow-burning fire. As a result, creosote residue accumulates on the flue
lining. When ignited this creosote makes an extremely hot fire.
The chimney connector and chimney should be inspected at least once every two months
during the heating season to determine if a creosote buildup has occurred. If creosote has
accumulated (⅛" [3mm] or more), it should be removed to reduce the risk of a chimney fire.
Installation and Operation Manual - Solution 3.5-I
4
A
2
B
3
5
6
Page 29