Operating The Insert - Enerzone SOLUTION 3.5 INSERT Installation And Operation Manual

4. Operating the Insert

This wood heater has a manufacturer-set minimum low burn rate that must not be
altered. It is against federal regulations to alter this setting or otherwise operate this
wood heater in a manner inconsistent with operating instructions in this manual.
Before using the insert, the following steps should be completed :
• Empty the combustion chamber and install the air control handle (A) with the set screw (B) as
shown below:
Empty the combustion chamber
• Install the combustion chamber side bricks as shown below.
• Install the ash lip and the blower (see
• Install the faceplate (See
The following step is optional :
• Install the fresh air intake (See
Page 18
«Appendix 1: Blower and Ash Lip
«Appendix 3: Faceplate And Trims
«Appendix 2: Fresh Air Intake Kit
Installing the air control wood handle
Installation»);
Installation»).
Installation»).
Installation and Operation Manual - Solution 3.5-I