Bluetooth Unpairing; Bluetooth Connection - Socket CX2895-1508 Quick Start Manual

BLUETOOTH UNPAIRING

Note: This procedure will put the CHS in discoverable mode.
Step 1: unpairing the CHS: Delete the Bluetooth Pairing
If the CHS is paired with a device, unpair it before trying to
connect to a different device.
1. Power on the CHS.
2. Press and hold down the trigger button.
3. Press and hold down the power button.
4. After you hear 3 beeps, release both buttons.
The CHS will unpair and automatically power off. The next time you
power on the CHS, it will be discoverable.
Step 2: Remove the CHS from the Bluetooth list on the host device
Important: Both steps above must be done to complete the unpairing.
20
automatic Reconnections
After you power on the CHS, it will automatically try to connect to
the last device it was connected to.
• Make sure the device is in range with Bluetooth On.
• If using HID mode, pressing the trigger button will enforce the con-
nection.
• If using iOS mode, make sure the Scanner-enabled Application is
active.
• If using SPP mode, make sure SocketScan 10 software or an applica-
tion developed with SocketScan 10 SDK is running.
Make sure the device is on and in range. While the CHS is attempting
to connect the Blue LED will blink every second.
• If a connection is made, the Blue LED will blink every 3 seconds.
• If a connection is not made after 30 tries, the CHS will emit a long
beep.

BLUETOOTH CONNECTION

21