Table of Contents
Advertisement
de
Malfunctions and remedial measures
advertisement
H: 95
alternating with
"Ÿš
according to program
pass
H: 32
alternating with
"Ÿš
according to program
pass
More ads
Errors and measures to correct them.
Disruptions
Water is leaking out of
the device.
The washing machine door
cannot be opened.
No water inlet.
No detergent is
washed in.
48
Cause / remedy
No water was detected during the drying phase. Poor drying result
possible.
~ " Clogged water inlet filter "on page 45
The imbalance control system has stopped spinning due to uneven
distribution of the laundry. Distribute small and large items of laundry
evenly in the drum.
Open the program selector Û ( The end) set, wait five seconds and
then switch the device on again. If the display reappears, call
customer service.
Cause / remedy
Fasten or replace the drain hose properly. Tighten the
■
screw connection on the inlet hose.
■
~~~ ( Rinse hold = no pumping at the end) is activated (depending
■
on the model). The program by selecting Spin / Drain and
pressing Start reloading continue.
The temperature in the drum is too high to open the door.
■
The safety function is activated. Stop the program? The
■
water level in the drum is too high.
■
Can the door only be opened using the emergency release?
■
~ " Emergency release "on page 46
Does the program not
■
start? Is the tap open?
■
Is the filter in the water inlet blocked?
■
~ " Clogged water inlet filter "on page 45
Note:
If an additional water filter has been installed (depending on the
model), check it for contamination and clean it if necessary
~ separate installation and cleaning instructions for the
water filter. Is the inlet hose kinked or pinched?
■
Advertisement
Table of Contents
