Device Settings; Sensors; Imbalance Control System - Siemens WN34A140 Manual

Q

Device settings

The following settings can be changed
F.
Device settings
be:
The end signal volume The key signal
■
volume Switch the drum care
■
information signal on / off
■
To change these settings, the setting
mode must be activated.
1/2/3/4 ...
Program selector position
nen
Activate setting mode:
1. Set the program selector to position 1.
The device is switched on.
2. The key sling Hold down and at the
same time turn the program selector to
position 2 to the right. The key sling
let go.
The setting mode is activated and the
default setting appears on the display
panel.
Change the volume and the drum care
warning signal
With the key Completed in the following
settings can be changed at the
corresponding program selector
positions:
2: The end signal volume
■
Device settings
3: The key signal volume
■
0 = off, 1 = quiet, 2 =
medium, 3 = loud, 4
= very loud
4: Switch the drum care information
■
signal on / off
Ž A
Πthe end
Exit setting mode
The process can now be ended and the
program selector to the position Û
(The end) The settings are saved.
H

Sensors

Imbalance control system

Sensors
The automatic imbalance control system
detects imbalances and ensures even
laundry distribution through repeated
spinning attempts.
For safety reasons, if the laundry is very
poorly distributed, the speed is reduced or
it is not spun.
Note: Put small and large items of
laundry in the drum.
de
41