Table of Contents
Advertisement
de
Malfunctions and remedial measures
Disruptions
Repeated strong
Foaming
Detergent / fabric softener
ler is dripping from the man
cuff and collect
on the loading door
or in the cuff fold.
The spin result
is not satisfactory.
The laundry is wet or
too damp.
It is thrown several
times.
The program lasts
longer than usual.
The program duration
changes during the
wash cycle.
Odors, staining
in the device
Loud noises, vibrations
and "wandering" of the
device during the
Skidding.
The display panel
indicator lamps do not
work during operation.
There are detergent
residues on the laundry.
stands.
50
Cause / remedy
Has too much detergent been used? Add less detergent for the
next wash cycle with the same load.
There is too much detergent / fabric softener in the dispenser. Do not
place the dosing container further than the mark Max. fill up.
Not a fault - the imbalance detection system canceled the spin due
■
to uneven distribution of the laundry. Distribute small and large
items of laundry evenly in the drum.
Is the additional program setting Anti-crease selected (depending on the
■
model)?
Is the additional program setting quiet or the program quiet selected
■
(depending on the model)?
Is the selected speed too low?
■
Not a fault - the imbalance detection system compensates for an imbalance.
Not a fault - the imbalance detection system compensates for an imbalance by
■
distributing the laundry several times.
Not a fault - foam detection is activated. - A rinse cycle has been
■
activated.
Not a fault - the program sequence is optimized for the respective washing
process. This can lead to a change in the program duration shown in the display
panel.
The program Cotton 90 ° C run without washing. Use
powder detergent or a detergent containing bleach.
Note:
To avoid foam formation, only use half the amount of detergent
recommended by the detergent manufacturer. Do not use wool or
mild detergents.
Is the device aligned? ~ " Align "on page 19
■
Are the device feet fixed? Fix the device feet.
■
Have the transport locks been removed?
■
~ " Remove the transport locks "on page 15
Has there been a power failure?
■
Have the fuses blown? Reset / replace the fuses.
■
If the fault occurs repeatedly, call customer service.
■
Some phosphate-free detergents contain residues that are insoluble in
■
water.
Wash or brush out the laundry after washing.
■
Advertisement
Table of Contents
