Table of Contents
Advertisement
de
Positioning and connecting
Power cable change (if necessary) can only be
■
carried out by a qualified electrician.
Replacement power cable available from
customer service.
Multiple plugs / couplings and
■
extension cables are not used.
When using a residual current circuit
■
breaker, only one type with this
symbol is used: z.
Only this symbol guarantees
compliance with the current
regulations.
the power plug is accessible at all
■
times.
the power cord is not kinked,
■
squashed, modified, cut or come into
contact with heat sources.
Before washing for the first time
The device was thoroughly tested before it
left the factory. In order to remove any test
water residues, the
program Cotton 90 ° C without
Do laundry.
Note:
The device must be properly
■
installed and connected.
~ " Positioning and connecting "on
page 13
Damaged devices must not be put
■
into operation.
1.
Plug in the power plug. Open
2.
the tap.
3.
Close the washing machine door; do not put any
laundry in the machine.
4th
The program Cotton 90 ° C
choose.
5.
Open the detergent drawer. Pour
6th
approx. 1 liter of water into the dosing
tank II.
7th
Pour universal detergent into dispenser
II for light soiling in accordance with
the manufacturer's instructions.
20th
Note:
To avoid foaming, only use
half the recommended amount of
detergent. Do not use wool or mild
detergents.
8th.
Close the detergent drawer.
9.
Start reloading choose.
10.
When the program has ended, open
the program selector Û ( The end)
to adjust.
The device is now ready for use.
transport
z. B. when moving
Preparatory work:
1.
Turn off the tap.
2.
Reduce the water pressure in the inlet
hose. ~ Page 45
Pump off the remaining water. ~ Page 43
3.
4th
Disconnect the device from the mains.
5.
Remove the hoses.
6th
Empty the dosing container.
Caution!
Danger of damage to the appliance
from detergent or fabric softener
leaking out of the dispenser
Leaking detergent or fabric softener
can impair the function of the
appliance and
z. B. cause electronic damage. Empty
the dosing container before
transporting the device.
Install transport locks:
1.
Remove and keep covers.
Note:
Use a screwdriver if necessary.
Advertisement
Table of Contents
