Siemens WN34A140 Manual page 51

Disruptions
Spinning noise during
rend the drying
phase.
There is fluff on the
laundry.
Water inlet noise
during the drying
phase
Longer drying
duration
The drying pro-
gram does not start.
Wrinkling
Cause / remedy
An innovative process called thermal spinning reduces energy
consumption during the drying phase. This is deliberately designed.
Please wait until the end of the program.
The program cotton Ž ( cold) without laundry and detergent to
remove any lint that may have accumulated in the drum during
the previous drying cycle.
The washer dryer uses water condensation technology. Water is
constantly required to dry the laundry. The tap must therefore be
turned on until the end of the drying phase.
The program cotton Ž ( cold) to remove any lint that has
■
accumulated in the drum during the drying phase.
If the ambient temperature is higher than 30 ° C, the drying
■
time may be longer.
Insufficient air circulation in the room can extend the drying
■
time. Ventilate the room.
Has the additional drying program setting not been selected? Has the
■
washing machine door been closed correctly?
■
Creases occur if the maximum load is exceeded or the wrong
■
program has been selected for the type of fabric. All necessary
information can be found in the program overview table.
Remove the clothes immediately after drying. Leaving it in the
■
drum can cause creases.
Malfunctions and remedial measures
de
51