Table of Contents
Advertisement
de
Program preferences
0
Program preset
lungs
You can change the default settings of selected programs. the
Program presets
G
Settings can also be changed while the
selected program is running. The effects
depend on the progress of the program.
Temp. ° C
Before and after the start of the program,
the temperature setting can be changed
depending on the progress of the
program by adjusting the desired speed
on the display.
The maximum temperature that can be set
depends on the selected program.
sling
Before and during the program,
depending on the progress of the
program, you can change the spin speed
(in rpm, revolutions per minute) by
adjusting the desired speed on the display.
setting 2: 2 = " No spin ". Without final
spin, the water is only pumped out. The
laundry remains wet in the drum, eg if
items of laundry should not be spun.
"No spinning" can be selected to avoid
creasing if the laundry is not removed
from the appliance immediately at the
end of the program.
The maximum speed that can be set
depends on the model and the selected
program.
34
Completed in
Before the program starts can the pro
End of the gram ("finish in" time) in steps
of 0.5 h (h = hour) (between "at least
selectable end time" and 9.5 h) or in steps
of whole hours (between 10 h and 24 h)
can be preselected up to a maximum of 24
hours.
In addition:
1.
Select a program (with the exception of
the program O Time pro
grams drying). *
The program duration for the selected
program, e. B. 2:30 ( Hours: minutes)
is displayed.
2.
The key Completed in Press repeatedly
until the required number of hours is
displayed.
3.
The key Start reloading select
len.
The program starts.
The selected number of hours
z. B. 8 h, is shown in the display and
counts down until the program
begins. The program duration is then
displayed.
Note:
The program duration is
automatically adjusted while the program
is running. Changes to the program
default settings or additional program
settings also result in changes to the
program duration.
After the program start ( when a
"Finish in" time has been selected and the
program has not yet been started) the
preselected number of hours can be
changed as follows:
1.
The key Start reloading choose.
2.
The key Completed in press
repeatedly to change the number of
hours.
3.
The key Start reloading choose.
*
Depending on the model
Advertisement
Table of Contents
