Program Standard; Settings; C Temperature; Spin Speed (Center Speed Selection) - Siemens WN34A100EU Manual

0

Program standard

settings

You can change the default settings of selected programs.
Program Default Settings
g
The settings can be changed even while
the selected program is running. The
effects depend on the progress of the
program.
°C Temperature
(Temperature)
Before and after the program has started,
you can change the temperature setting,
depending on the phase the program is in,
by setting it to the desired value via the
display.
The maximum temperature that can
be set depends on the selected
program.
0 Spin Speed (Center Speed
Selection)
Depending on the phase the program is
in, you can change the spin speed before
and during the program by setting it to
the desired value (in rpm; revolutions per
minute) via the display.
Institution 2: 2 ="Do not spin". The rinse
water is pumped out, but there is no final
spin. The laundry remains wet in the
drum, e.g. for items that are not
may be centrifuged.
You can select "No Spin" to avoid creasing
if the laundry is not taken out immediately
after the program has finished.
The maximum speed that can be set
depends on the model and program
selected.
Program default settings

B Finish in/Time Dry

Before the program starts, You can
the end of the program ("Finish in" time in
steps of 0.5 h (h = hour) between
"minimum selectable end time" and 9.5 h)
or in steps of 1 hour (between 10 h and 24
h) until select a maximum of 24 hours.
To do this:
1. Select a program (except
O myTime dry* program). The
program duration becomes
displayed for the
selected program, e.g. 2:30
(hours:minutes).
2. Select the B Finish in/Time Dry knob
repeatedly until the desired
number of hours is displayed.
3. Select the IStart/Reload knob.
The program starts.
The selected number of hours (eg.
8h) is displayed on the display panel
and counts down until the program
starts. Then the program duration is
displayed.
Note: The length of the program is
automatically adjusted when the
program is run. Changes to the
program default settings or additional
program settings can also change the
program duration.
After starting the program
(when a "Finish in" time has been selected
and the program has not yet started) you
can change the preset number of hours as
follows:
1.
Select the IStart/Reload knob.
2.
Select the B Finish in/Time Dry knob
repeatedly to change the number of
hours.
3.
Select the IStart/Reload knob.
*
Depending on the model
NL
37