Panasonic PT-REZ80 Operating Instructions Manual page 188

Note
f If no CEC-compatible device is connected to <HDMI IN 1> terminal, <HDMI IN 2> terminal or <SLOT> terminal, there is no device
displayed at [HDMI 1], [HDMI 2] or [SLOT] and [----] is displayed.
f Wireless Presentation System Receiver Board (Model No.: TY‑SB01WP) supports the power on/power off link and the input switching
related to the power link of the CEC function. It does not support the menu operation of the CEC-compatible device using the projector
remote control.
f For the Function Board of other manufacturers and the CEC-compatible devices connected to the Function Board of other manufacturers,
not all the operations are guaranteed.
f To exit the HDMI CEC operation, press the <MENU> button.
Changing the menu code
The menu code that calls up the operation menu of the CEC-compatible device varies depending on the device
manufacturer. If you cannot call up the operation menu of a CEC-compatible device from the HDMI CEC operation
screen, change the menu code setting.
1) Press as to select [HDMI CEC].
2) Press qw to select [ON].
3) Press the <ENTER> button.
f The [HDMI CEC] screen is displayed.
4) Press as to select [MENU CODE].
5) Press qw to switch the item.
f The items will switch each time you press the button.
f Select the menu code from [1] to [6].
Setting the power link
Make settings for the power link operations between the projector and CEC-compatible devices.
[PROJECTOR -> DEVICE]
Set the power link operation from the projector to the CEC-compatible device.
1) Press as to select [HDMI CEC].
2) Press qw to select [ON].
3) Press the <ENTER> button.
f The [HDMI CEC] screen is displayed.
4) Press as to select [PROJECTOR
5) Press qw to switch the item.
f The items will switch each time you press the button.
[DISABLE]
[POWER OFF]
[POWER ON/OFF]
[DEVICE -> PROJECTOR]
Set the power link operation from the CEC-compatible device to the projector.
1) Press as to select [HDMI CEC].
2) Press qw to select [ON].
188 - ENGLISH
Chapter 4 Settings — [PROJECTOR SETUP] menu
->
DEVICE].
Disables the power link operation.
Select this item if you do not want the power status of the CEC-compatible device to react to the power status
of the projector.
Enables power‑off link operation.
When you turn off the power of the projector and put it in standby mode, all CEC‑compatible devices
connected to the <HDMI IN 1> terminal, <HDMI IN 2> terminal and Function Board will enter standby mode.
Power-on link operation is disabled.
Enables power‑on link operation and power‑off link operation.
If you turn on the projector and start projection, the CEC-compatible device connected to the <HDMI IN 1>
terminal, <HDMI IN 2> terminal or Function Board will turn on.
When you turn off the projector and put it in standby mode, all CEC‑compatible devices connected to the
<HDMI IN 1> terminal, <HDMI IN 2> terminal and Function Board will enter standby mode.