Table of Contents
Advertisement
Setting [REGULAR CALIBRATION]
Set whether to measure the brightness and color of the light source at a specified time.
1)
Press as to select [BRIGHTNESS CONTROL].
2)
Press the <ENTER> button.
f The [BRIGHTNESS CONTROL] screen is displayed.
3)
Press as to select [REGULAR CALIBRATION].
4)
Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
[ON]
f Proceed to Step 5) when [ON] is selected.
5)
Press as to select [CALIBRATION TIME].
6)
Press the <ENTER> button.
f The projector is in the adjustment mode (the time is blinking).
7)
Press qw to select "hour" or "minute", and press as or the number (<0> - <9>) buttons to set a
time.
f Selecting "hour" allows setting of only the hour in increments of one hour, and selecting "minute" allows
setting of only the minute in increments of one minute between 00 and 59.
8)
Press the <ENTER> button.
f [CALIBRATION TIME] is set.
Note
f The [REGULAR CALIBRATION] setting will be reflected at the time when the item is switched using qw.
f The [CALIBRATION TIME] setting will be reflected at the time when you enter the time and then press the <ENTER> button.
f The [REGULAR CALIBRATION] setting item is common with the following menu item.
g The [PROJECTOR SETUP] menu → [BRIGHTNESS CONTROL] → [BRIGHTNESS CONTROL SETUP] → [REGULAR CALIBRATION]
f The [CALIBRATION TIME] setting item is common with the following menu item.
g The [PROJECTOR SETUP] menu → [BRIGHTNESS CONTROL] → [BRIGHTNESS CONTROL SETUP] → [CALIBRATION TIME]
Setting [CALIBRATION MESSAGE]
Set whether to display the time to complete the measurement while the brightness and color of the light source
are measured.
1)
Press as to select [BRIGHTNESS CONTROL].
2)
Press the <ENTER> button.
f The [BRIGHTNESS CONTROL] screen is displayed.
3)
Press as to select [CALIBRATION MESSAGE].
4)
Press qw to switch the item.
f The items will switch each time you press the button.
[ON]
[OFF]
Note
f The [CALIBRATION MESSAGE] setting will be reflected at the time when the item is switched using qw.
f The [CALIBRATION MESSAGE] setting item is common with the following menu item.
g The [PROJECTOR SETUP] menu → [BRIGHTNESS CONTROL] → [BRIGHTNESS CONTROL SETUP] → [CALIBRATION MESSAGE]
Chapter 4 Settings — [PROJECTOR SETUP] menu
Does not measure the brightness and color of the light source periodically.
Measures the brightness and color of the light source by the brightness sensor at the time specified
by [CALIBRATION TIME].
Displays the time to complete the measurement while the brightness and color of the light source are
measured by the brightness sensor.
Does not display a message during the measurement.
ENGLISH - 167
Advertisement
Table of Contents
