Table of Contents
Advertisement
Chapter 3 Basic Operations — Switching on/off the projector
Initial setting (standby mode)
Set the operation mode during standby. The factory default setting is [NORMAL], which allows you to use the
network function during standby. To keep power consumption low during standby, set this item to [ECO].
After completed the initial setting, you can change the setting from the [PROJECTOR SETUP] menu →
[STANDBY MODE].
1)
Press qw to switch the setting.
2)
Press the <ENTER> button to proceed to the initial setting.
Initial setting (screen setting)
Set the screen format (aspect ratio) and display position of the image.
After completed the initial setting, you can change the settings of each item from the [DISPLAY OPTION] menu →
[SCREEN SETTING].
1)
Press qw to switch the setting.
f The setting will change each time you press the button.
2)
Press as to select [SCREEN POSITION].
f [SCREEN POSITION] cannot be selected or adjusted when [SCREEN FORMAT] is set to [16:10].
3)
Press qw to adjust.
4)
Press the <ENTER> button to proceed to the initial setting.
INITIAL SETTING
NORMAL
STANDBY MODE
When set to ECO, network functions and SERIAL OUT
terminal, DC OUT terminal, and some RS-232C
commands are not available during standby.
CHANGE
SET
ENTER
INITIAL SETTING
SCREEN FORMAT
16:10
SCREEN POSITION
Set as necessary for the screen in use.
CHANGE
MENU SELECT
SET
ENTER
INITIAL SETTING
16:9
SCREEN FORMAT
0
SCREEN POSITION
Set as necessary for the screen in use.
MENU SELECT
CHANGE
SET
ENTER
4/7
5/7
5/7
ENGLISH - 75
Advertisement
Table of Contents
