Table of Contents
Advertisement
f The shutter operation by the shutter synchronization function will follow the setting of the [DISPLAY OPTION] menu → [SHUTTER
SETTING] on the projector that [MODE] is set to [MAIN].
f When the input signal to each linked projector is not synchronized, the timing of the shutter operation between the projectors may shift up to
1 frame while using the shutter synchronization function.
f The shutter function of the projector with [MODE] set to [SUB] can be operated individually. The shutter operation at this time will follow the
setting of the [DISPLAY OPTION] menu → [SHUTTER SETTING] set in that projector.
[TERMINAL SELECT]
Set the terminals to be used when the contrast synchronization function or the shutter synchronization function is
used.
1)
Press as to select [MULTI PROJECTOR SYNC].
2)
Press the <ENTER> button.
f The [MULTI PROJECTOR SYNC] screen is displayed.
3)
Press as to select [TERMINAL SELECT].
4)
Press qw to switch the item.
f The items will switch each time you press the button.
[BNC]
[SERIAL]
Note
f [BNC] and [SERIAL] cannot be used simultaneously within the linked projectors.
[RS-232C]
Set the communication conditions of the <SERIAL IN> / <SERIAL OUT> terminals. For details on the connection
method for RS-232C communication, refer to "<SERIAL IN> / <SERIAL OUT> terminal" (x page 284).
Setting the communication condition of the <SERIAL IN> terminal
1)
Press as to select [RS-232C].
2)
Press the <ENTER> button.
f The [RS-232C] screen is displayed.
f Proceed to Step 5) unless the optional DIGITAL LINK Terminal Board (Model No.: TY-SB01DL) or the
Function Board by other manufacturers is installed in the slot.
3)
Press as to select [INPUT SELECT].
4)
Press qw to switch the item.
[PROJECTOR]
[DIGITAL LINK]
[SLOT]
5)
Press as to select [(IN) BAUDRATE].
6)
Press qw to switch the item.
f The items will switch each time you press the button.
[9600]
[19200]
[38400]
7)
Press as to select [(IN) PARITY].
8)
Press qw to switch the item.
f The items will switch each time you press the button.
Chapter 4 Settings — [PROJECTOR SETUP] menu
Uses the <MULTI SYNC IN> / <MULTI SYNC OUT> terminals (BNC).
Uses the <SERIAL IN> / <SERIAL OUT> terminals.
Performs the RS-232C communication with the <SERIAL IN> terminal of the projector.
Performs the RS-232C communication via the optional DIGITAL LINK output supported device (Model
No.: ET-YFB100G, ET-YFB200G) and the <DIGITAL LINK IN/LAN> terminal of the optional DIGITAL
LINK Terminal Board (Model No.: TY-SB01DL) installed in the slot.
Performs communication via the Function Board by other manufacturers installed in the slot.
Select the proper speed.
ENGLISH - 179
Advertisement
Table of Contents
