Table of Contents
Advertisement
11) After the name is changed, press asqw to select [OK], and press the <ENTER> button.
f Saving of the lens memory is completed, and returns to the [LENS MEMORY NAME CHANGE] screen.
f If you press asqw to select [CANCEL] and then press the <ENTER> button, the changed name will not
be registered.
f If you press asqw to select [DEFAULT] and press the <ENTER> button, the changed name will not be
registered and the default name will be used.
f If you select [OK] without entering any characters and press the <ENTER> button, the default name will be
used.
Note
f The numeric value information of the periphery focus position is displayed only in following cases.
g ET-C1U100, ET-C1W300, ET-C1W400, ET-C1W500
[LENS HOME POSITION]
Operate in following procedure to move the projection lens to the home position.
1)
Press as to select [LENS].
2)
Press the <ENTER> button.
f The [LENS] screen is displayed.
3)
Press as to select [LENS HOME POSITION].
4)
Press the <ENTER> button.
f The confirmation screen is displayed.
5)
Press qw to select [OK], and press the <ENTER> button.
f The projection lens is moved to the home position.
Note
f [PROGRESS] is displayed in the menu while the projection lens is moved to the home position.
f The home position does not match with the optical image center position.
f [LENS HOME POSITION] can also be executed by pressing the <DEFAULT> button on the remote control while the lens shift adjustment
screen is displayed.
[LENS CALIBRATION]
Detect the lens shift adjustment limit value, and perform the calibration in the adjustment range. Execute the lens
calibration after attaching the projection lens.
1)
Press as to select [LENS].
2)
Press the <ENTER> button.
f The [LENS] screen is displayed.
3)
Press as to select [LENS CALIBRATION].
4)
Press the <ENTER> button.
f The confirmation screen is displayed.
5)
Press qw to select [OK], and press the <ENTER> button.
f The lens calibration is started.
f After completing the calibration in the adjustment range, the projection lens will move to the home position.
f To cancel, select [CANCEL].
Note
f [PROGRESS] is displayed in the menu during lens calibration. The operation cannot be canceled during calibration.
f [INCOMPLETE] is displayed when the lens calibration is not performed correctly.
f The origin position of the lens mounter and the home position of the projection lens are automatically updated when the lens calibration
is performed. The home position is an origin position of the lens shift (vertical position and horizontal position of the lens) based on the
calibration result. It does not match with the optical image center position.
f Pressing the <FOCUS> button on the remote control for at least three seconds will also display the confirmation screen for lens calibration
execution.
156 - ENGLISH
Chapter 4 Settings — [PROJECTOR SETUP] menu
Advertisement
Table of Contents
