Connect Computer; Turn On Your Mini-Mx - RGBlink mini-mx User Manual

Warning:
1.For U disk, please use one with USB 3.0 port.
2.For SSD, Please check if it needs extra power supply.
3.OTG cable only for file transfer cannot be used for streaming.
4.For dual-channel streaming, or use UVC output/recording function at the same time, the touch
screen may get sluggish or run slowly.

2.6 Connect Computer

Web Control: Connect computer and mini-mx with CAT6 cable.
Record: Insert U disk to mini-mx's USB-C port labeled number 1
Stream: Connect mini-mx's USB-C labeled number 2 and computer's USB 3.0 port with USB 3.0
cable. (Note: the color of USB 3.0 port is blue or with SS silkscreen)
Minimum System Requirements for macOS
● macOS 11.0 Big Sur or later
● macOS 10.15 Catalina
Minimum System Requirements for Windows
● Microsoft Windows 10 64-bit
Warning：
1.The IP address of the mini-mx must be in the same LAN as the computer.
2.It is recommended to use USB-C cable provided. For streaming via mobile phone, please use standard
data cable.

2.7 Turn on Your mini-mx

After mini-mx is connected to power supply, push the power switch on the rear panel, the device
will show mini-mx logo and then enter to the operation interface.
© Xiamen RGBlink Science & Technology Co., Ltd.
| support@rgblink.com | www.rgblink.com
Ph: +86 592 5771197
16