Start-Up; Teaching-In; Mounting - HomeMatic HMIP-eTRV Mounting Instruction And Operating Manual

Start-up

5 Start-up
5.1

Teaching-in

Please read this entire section before starting
the teach-in procedure.
First set up your Homematic IP Access Point via
the Homematic IP app to enable operation of
other Homematic IP devices within your system.
For further information, please refer to the oper-
ating manual of the Access Point.
To integrate the radiator thermostat into your system and
enable it to communicate with other Homematic IP de-
vices, you must teach-in the device to your Homematic
IP Access Point first.
To teach-in the radiator thermostat, please proceed as
follows:
• Open the Homematic IP app on your smartphone.
• Select the menu item "Teach-in device".
• Remove the insulation strip from the battery
compartment (D) of the radiator thermostat.
Teach-in mode remains activated for 3 minutes.
You can manually start the teach-in mode for an-
other 3 minutes by pressing the system button (C)
shortly (see figure 3).
40
• Your device will automatically appear in the
Homematic IP app.
• To confirm, please enter the last four digits of the
device number (SGTIN) in your app or scan the
QR code. Therefore, please see the sticker sup-
plied or attached to the device.
• Please wait until teach-in is completed.
• If teaching-in was successful, the LED lights up
green. The device is now ready for use.
If the LED lights up red, please try again.
• Select the desired solution for your device.
• In the app, give the device a name and allocate
it to a room.
5.2

Mounting

Please read this entire section before starting to
mount the device.
The Homematic IP Radiator Thermostat is easy to install,
and can be done without draining heating water or in-
tervening in the heating system. No special tools are re-
quired, nor does the heating have to be switched off.
The metal nut (A) attached to the radiator thermostat can
be used universally and without accessories for all valves
Start-up
41