Mounting The Support Rails - Compaq ProLiant 850R Setup And Installation Manual

3. Insert the tip of the fitting tool through the other side of the perforation
and hook the opposite lip of the cage nut.
Figure 2-5. Inserting cage nut
4. Using the fitting tool as a lever, pry the cage nut into position.

Mounting the Support Rails

WARNING: To reduce the risk of personal injury or damage to the
!
equipment, be sure that the rack leveling feet are extended to the floor
and support the full weight of the rack. Each rack must be level and
stable. Racks that are not coupled together require the installation of
stabilizers. This must be done before you perform any work on the rack.
See the Rack Planning and Installation Guide , for more information on
leveling feet and stabilizers.
1. Align the support rail rear flange on the inside of the rear rack frame
with the corresponding holes for screw placement. Insert
two M6 x 1.0-12L Phillips screws from the outside of cage and tighten.
2-13