Compaq ProLiant 850R Setup And Installation Manual page 65

3-14 Installing Hardware Options
7. Release the original processor from the socket by
on the ZIF socket out and upward.
Figure 3-15.
8. Lift the processor out of the socket .
Now that the old processor has been removed, the following must occur:
If you have a Processor Power Module to install, you should:
1. Remove the existing Processor Power Module. Follow the "Removing a
Processor Power Module," procedure later in this chapter.
2. Install the Processor Power Module. Follow the "Installing a Processor
Power Module," procedure later in this chapter.
3. Install a New Processor (CPU) in Socket 1. Follow the "Installing a New
Processor (CPU) in Socket 1," procedure below.
2
Releasing the ZIF socket and removing the processor
CAUTION:
The handle on the ZIF socket in your server may not be
identical to the handle shown in the drawing. All handle types perform the
same function.
pulling the handle
1