Compaq ProLiant 850R Setup And Installation Manual page 120

B-6 Installing a New Battery
4. Remove the backing from the adhesive on the hook-and-loop fastener
strip. Place the battery and the hook-and-loop fastener strip as shown in
the following illustration.
Figure B-4. Installing the battery to the disk drive cage
5. Reinstall all Boards on side B of the Riser Board.
6. Replace the server cover.
7. Place the sticker included with your battery kit on the back of your
server above the power connector.
8. Plug in the server and reconnect any external devices.
9. Turn on the server.
10. Run the Compaq System Configuration Utility to reconfigure the
system. Refer to Chapter 4, "System Configuration and Utilities."
WARNING:
To reduce the risk of electrical shock or
!
damage to your equipment, do not disable the power cord
grounding feature. This equipment is designed to be
connected to a grounded (earthed) power outlet that is easily
accessible to the operator. The grounding type plug is an
important safety feature.