5.
Remove the backing from the adhesive on the hook-and-loop fastener
strip.
6.
Place the battery and the hook-and-loop fastener strip on the designated
chip, as shown in the following illustration.
7.
Plug the battery connector onto pins 1-4 of header E2 on the System
Board.
Figure B-2.
Attaching the battery on the designated chip
8.
Reverse steps 1 through 3 to close up the server and reinstall it into the
rack.
9.
Place the sticker included with your battery kit on the back of your
server above the power connector.
10. Plug in the server and reconnect any external devices.
B-3