Table of Contents
Advertisement
USER MANUAL
PRECELLYS
Evolution Touch
®
Heavy load hazard: there is a heavy load sticker on the packaging
of the equipment. The Precellys Evolution Touch should be
carried by two operators, preferably. Safety shoes must be worn
by the operator during transportation.
High temperature hazard: this sticker warns about a hot surface.
The maintenance operator must wait at least 60 minutes after
the end of a cycle before carrying out work on the equipment.
Electrical hazard: before any maintenance operation, the
operator must disconnect the mains supply.
2.2.
Recap of the advice for using the power supply
Only use the device with the type of electrical power source
indicated on the label.
Do not pull on the cords. Hold the plug and not the cable when
plugging in or unplugging the cord.
Do not expose the device to sudden variations in temperature
and humidity, avoid shocks, intended for indoor use only.
Do not disassemble or repair the power supply by yourself.
There is a risk of electrocution.
Do not immerse the device, do not use the device in explosive
atmospheres or in wet environments.
Unplug the cord from the wall outlet before cleaning the unit.
The power supply may become hot during use. Before
transporting it, disconnect it and let it cool down.
Page
6
Failure to follow the instructions associated with
the symbol may result in physical injuries and
environmental damages.
The means of disconnection of the equipment is the mains
connector.
Disconnecting the power cord from the device cuts off the
power supply to the device.
Do not put the device in a place where it would be difficult to
operate the disconnecting mechanism.
The power cord must not be replaced with a part number other
than the one supplied with the product.
2.3
Risk of electric shock
Although the device is perfectly insulated and earthed, it is important
that all users are made aware of the risks associated with the use of liquids
near an electrical power supply. If any liquid is spilled, the device must be
immediately disconnected from the power supply by unplugging the mains
plug even if the device is in operation. The device should then be dried and
any spilled liquid should be wiped up.
- Do not plug the device back in until it has been
checked.
- The casing must not be removed by the operator
under any circumstances - Risk of electrocution.
To avoid any risk of an electric shock, the device's power supply must be
connected to an installation that complies with the applicable standards.
If the system does not start, the operator should
contact the manufacturer.
2.3.1
Fuse
The device contains an external fuse located on the rear panel. If they need to
be changed, they must be replaced with a fuse 5x20 - T 10 A - H 250 V. It can
be easily replaced by the user using a screwdriver (see § 9.3.3).
Page
7
Advertisement
Table of Contents
Need help?
Do you have a question about the PRECELLYS Evolution Touch and is the answer not in the manual?
Questions and answers