Table of Contents
Advertisement
Electrical
Specific Precautions/Power Source
Equipment Installation and Service
Equipment Specifications
Electrical
Voltage:
Amperage:
Wattage:
Air
Air Pressure Requirements:
Approximate Air Consumption:
TC33 Series Tire Changer Operation Instructions
The TC is manufactured to operate at a specific voltage and amperage rating.
Make sure that the appropriate electrical supply circuit is of the same voltage and
amperage ratings as marked on the TC.
WARNING: DO NOT ALTER THE ELECTRICAL PLUG. Plugging the
electrical plug into an unsuitable supply circuit will damage the
equipment.
Make sure that the electrical supply circuit and the appropriate receptacle is installed with
proper grounding.
To prevent the possibility of electrical shock injury or damage to the equipment when
servicing the TC, power must be disconnected by removing the power cord from the
electrical power outlet.
The TC is intended to operate from a power source that will apply 208-230VAC, 1 phase,
15 amp 50/60 Hz, power cable includes NEMA 20 amp plug, L6-20P, between the supply
conductors of the power cord. The power cord supplied utilizes a twist lock connector,
NEMA L6-20P. This machine must be connected to a 20 amp branch circuit. Please refer
all power source issues to a certified electrician. Refer to "Installation Instructions for TC
Tire Changer.
CAUTION:
A protective ground connection, through the grounding
conductor in the power cord, is essential for safe operation.
Use only a power cord that is in good condition.
A factory-authorized representative should perform installation.
This equipment contains no user serviceable parts. All repairs must be referred to a
qualified Hunter Service Representative.
208-230VAC, 1 phase, 50/60 Hz, power cable includes
NEMA 20 amp plug, L6-20P
15 amperes
3450 watts (peak)
115-175 PSI (8-12.0 bar)
4 CFM (110 Liters/Minute)
Getting Started• • • • 7
Advertisement
Table of Contents
