Table of Contents
Advertisement
4.
Slide the rubber boot off the positive
battery-cable clamp, and disconnect the positive
battery cable.
Connecting the Battery
1.
Install the positive battery cable (red) to the
positive (+) battery post
Figure 96
1. Positive battery cable
2.
Install the negative battery cable (black) to the
negative (-) battery post.
3.
Apply a coat of Grafo 112X (skin-over) grease,
Toro Part No. 505-47 to the battery posts and
battery-cable clamps.
4.
Slide the rubber boot over the positive
battery-cable clamp.
5.
Close and latch the hood; refer to
Hood (page
41).
Charging the Battery
1.
Disconnect the battery; refer to
the Battery (page
2.
Connect a 3 to 4 A battery charger to the battery
posts.
3.
Charge the battery at a rate of 3 to 4 A for 4 to
8 hours.
4.
When the battery is charged, disconnect the
charger from the electrical outlet and battery
posts.
5.
Connect the battery; refer to
Battery (page
53).
(Figure
96).
2. Negative battery cable
Closing the
Disconnecting
52).
Charging the
Servicing the Battery
Service Interval: Every 50 hours
Note:
Keep the terminals and the entire battery case
clean because a dirty battery will discharge slowly.
1.
Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2.
Open the hood; refer to
41).
3.
Check the condition of the battery.
Note:
Replace a worn or damaged battery.
4.
Disconnect the battery cables, and remove the
battery from the machine; refer to
the Battery (page
5.
Clean the entire battery case with a solution of
sodium bicarbonate (baking soda) and water.
6.
Rinse the case with clean water.
7.
Assemble the battery to the machine and
connect the battery cables; refer to
g375758
the Battery (page
8.
Close and latch the hood; refer to
Hood (page
Replacing a Fuse-Block
Fuse
The fuse block is in the control arm.
1.
Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2.
Open the 2 latches that secure control-arm cove
to the control arm, and remove the cover
97).
1. Control-arm cover
3.
Replace the open fuse
fuse type and amperage rating.
53
41).
Opening the Hood (page
Disconnecting
52).
53).
Closing the
41).
41).
Figure 97
2. Latch
(Figure
98) with the same
Connecting
(Figure
g375760
Advertisement
Table of Contents
