Table of Contents
Advertisement
Figure 109
1. Front jam nut (brake cable) 2. Rear jam nut
6.
Tighten the rear nuts to move the cable
backward, until brake pedal has 6 to 13 mm (1/4
to 1/2 inch) of free travel
the parking brake engages the wheels.
7.
Tighten the front jam nuts, ensuring that both
cables actuate the brakes simultaneously.
Note:
Ensure that the cable conduit does not
rotate while tightening the jam nuts.
Adjusting the
Parking-Brake Latch
If the parking brake fails to engage and latch, an
adjustment to the brake pawl is required.
1.
Prepare the machine, refer to
Maintenance (page
2.
Loosen the 2 screws securing the parking-brake
pawl to the frame
(Figure
108), before
Preparing for
41).
(Figure
110).
1. Brake cables
2. Screws (2)
g375942
3.
Press the parking-brake pedal forward until the
brake detent completely engages on the brake
pawl
(Figure
4.
Tighten the 2 screws locking the adjustment.
5.
Press the brake pedal to release the parking
brake.
6.
Check the adjustment and adjust it as required.
60
Figure 110
3. Parking-brake pawl
4. Brake detent
110).
g011617
Advertisement
Table of Contents
