Connecting The Battery; Operation; Aiming The Headlights - Toro 30639 Installation Instructions Manual

7

Connecting the Battery

No Parts Required
Procedure
1. Connect the negative battery cable to both batteries.
2. Install the access panel.

Operation

Using the Light and Hazard
Switches
•
Turn the key switch ON and press the light switch to the
ON position to activate the head lamps.
•
Press the hazard switch to the On position to activate the
front and rear flashing hazard lights.
•
Turn the key switch ON and press the left side of the
turn signal switch to activate the left turn signal and the
right side of the switch to activate the right turn signal.
The center position is off.
Note: Check the operation of the lights. Make sure the
correct lights are flashing when operating the turn signal
switch.

Aiming the Headlights

1. Loosen the mounting nuts to adjust the lights.
2. Adjust the lights per local standards.
10