Putting Into Operation - Kranzle LX-RP 1000 TST Operating Manual

Putting into operation

It is imperative that safety instructions be observed during
use of the high-pressure cleaner.
Neither set up or operate the LX-RP-series in rooms where there is a
risk of fire or explosion nor put it into puddles. Do not use the high-
pressure cleaner under water. If, none the less, the high-pressure
cleaner is operated in a hazardous area, the applicable safety
regulations are to be observed.
20
1. Install the water inlet filter (available as
an option) at the water inlet.
2. For moving the high-pressure cleaner
to the place of use, please release
locking break.
The high-pressure cleaner must not
be pulled with connected water
supply hose!
3. The LX-RP-series is a movable high-
pressure cleaner with sturdy trolleys
ideally suited for difficult terrain.
For steering the high-pressure cleaner
put the foot against the tipping
support and then pull the device
towards you.
Putting into operation
The plug coupling must not be actuated/handled during operation!
High risk of injury!
Prior to insertion, check plug coupling connection of lance for
cleanliness (sand, dirt ..) and use clear water to clean, if necessary.
Impurities may damage the sealing in the plug coupling.
When using high-pressure hose extensions take care that the max.
length of 20 m is not exceeded!
Accessories may only be connected to a Kränzle-approved trigger gun
with safety catch.
4. For high-pressure cleaners with hose
drum, please loosen the fixation and
then completely unwind the high-
pressure hose. Unwind high-pressure
hose straight and without nooses. The
high-pressure hose may leave signs
of abrasion on some floors. Alterna-
tively, please also find non-marking
high-pressure hoses in our range.
5. Mount the grey rotating screw con-
nection of the high-pressure hose onto
the trigger gun incorporating a safety
catch. Afterwards screw together
ensuring a snug and pressure-tight fit.
6. First pull back the retaining sleeve
of the safety trigger gun, then
insert lance into the plug coupling
sconnection of the safety trigger gun.
7. After insertion of the lance, release
retaining sleeve and make sure that
the lance is in a secure position.
Grease quick release nipple regularly
using acid-free grease.
21