Table of Contents
Advertisement
Putting into operation
It is imperative that safety instructions be observed during
use of the high-pressure cleaner.
Neither set up or operate the bully-series in rooms where there is a
risk of fire or explosion nor put it into puddles. Do not use the high-
pressure cleaner under water. If, none the less, the high-pressure
cleaner is operated in a hazardous area, the applicable safety
regulations are to be observed.
When using high-pressure hose extensions take care that the
max. length of 20 m is not exceeded!
18
1.
Move high-pressure cleaner to the
job site. The bully-series is a movable
high-pressure cleaner with sturdy
trolleys ideally suited for difficult
terrain and stairs.
2.
For high-pressure cleaners with hose
drum, however, it must be uncoiled
completely. Unwind high-pressure
hose straight and without nooses.
The high-pressure hose may leave
signs of abrasion on some floors.
Alternatively, please also find
non-marking high-pressure hoses
in our range.
3.
Tightly screw together high-pressure
hose and safety trigger gun.
Putting into operation
Prior to insertion, check plug coupling connection of lance for clean-
liness (sand, dirt ..) and use clear water to clean, if necessary.
Impurities may damage the sealing in the plug coupling.
Accessories may only be connected to a Kränzle-approved trigger gun
with safety catch.
Check the water inlet sieve for damage. Do not operate the
high-pressure cleaner without or with a damaged filter.
4.
First pull back the retaining sleeve
of the safety trigger gun, then insert
lance into the plug coupling connection
of the safety trigger gun.
5.
After insertion of the lance, release
retaining sleeve and make sure that
the lance is in a secure position.
Grease quick release nipple regularly
using acid-free grease.
6.
Check water inlet filter for cleanliness
prior to putting the high-pressure
cleaner into operation.
Manually unscrew plug-in coupling.
Take out the water inlet filter using
needle nose pliers and thoroughly
rinse it with clear water and clean
it with the other parts. If the sieve
is dirty, water can not get through
and pressure will not build up.
19
Advertisement
Table of Contents
