Putting Into Operation - Kranzle bully 980 TS Operating Manual

Putting into operation

It is imperative that safety instructions be observed during
use of the high pressure cleaner.
Neither set up or operate the bully-series in rooms where there is a
risk of fire or explosion nor put it into puddles. Do not use the high
pressure cleaner under water. If, none the less, the high pressure
cleaner is operated in a hazardous area, the applicable safety
regulations are to be observed.
20
1. Move high pressure cleaner to the job
site. The bully-series is a movable high
pressure cleaner with sturdy trolleys
ideally suited for difficult terrain and
stairs.
Putting into operation
Prior to insertion, check plug coupling connection of lance for clean-
liness (sand, dirt ..) and use clear water to clean, if necessary.
Impurities may damage the sealing in the plug coupling.
2. Unwind high pressure hose straight and
without nooses. For high pressure clea-
ners with hose drum, however, it must
be uncoiled completely. (When extending
the high-pressure hose please consider
the maximum length of 20 m!)
3. Without hose drum:
For high pressure cleaners without hose
drum the high pressure hose included in
the scope of the delivery must be screwed
with the pump outlet in a tight and pres-
sure tight manner.
4. Tightly screw together high-pressure
hose and safety trigger gun.
5. First pull back the retaining sleeve
of the safety trigger gun, then insert
lance into the plug coupling connection
of the safety trigger gun.
6. After insertion of the lance, release
retaining sleeve and make sure that
the lance is in a secure position.
Grease quick release nipple regularly
using acid-free grease.
21