Table of Contents
Advertisement
1.5.
Connectors - Video-Interface
The video-interface converts the video signals of connected after-market sources in a factory
monitor compatible picture signal which is inserted in the factory monitor, by using separate
trigger options. Further it reads the vehicle's digital signals out of the vehicle's CAN-bus and
converts them for the video interface.
1.6.
Settings of the 8 Dip switches (black)
Some settings have to be selected by the 8 dip-switches at the
video-interface. Dip position down is ON and position up is OFF.
Dip
Function
1
Power supply
output
(red wire)
2
CVBS AV1-input
3
CVBS AV2-input
4
No function
5
Rear-view cam type
6
Frontcam
back-switching
for 10 seconds
7
No function
8
Monitor type
See the following chapters for detailed information.
After each Dip-switch-change a power-reset of the Can-box has to be performed!
Version 26.05.2023
ON (down)
+12V (max. 3A) when reverse gear
is engaged incl. 10 seconds delay
and +12V by manual switching to
front camera by keypad
enabled
enabled
after-market
enabled
Low resolution monitor
If you do not know the resolution, test both settings.
Power reset after change of dip switches necessary.
HW: CAM(V100)/(V52)
OFF (up)
+12V (max. 3A) ACC
disabled
disabled
Set to OFF
factory or none
disabled
Set to OFF
High resolution monitor
RL4-NAC08
Advertisement
Table of Contents
