KVH Industries TracPhone V11 HTS User Manual page 122

TracPhone V11-HTS User's Guide
Troubleshooting
128
No. Description
269 Error: The antenna cannot determine which type of LNB is
installed. Either the LNB type was not programmed at the
factory, or the antenna's memory (EEPROM) has been
cleared or corrupted. Contact KVH.
271 Error: The ICM is incompatible with the antenna's LNB.
The LNB is configured for HTS, while the ICM is not.
Contact KVH.
272 Error: The antenna's power/thermal module is
incompatible with HTS. Contact KVH.
401 Warning: No NMEA 0183 heading input detected. Check
the NMEA 0183 talker and its wires connected to the back
of the ICM.
404 Warning: Antenna is unwrapping its coiled internal cable.
Normal operation should resume within one minute.
410 Warning: The ICM has lost Ethernet communications with
its built-in modem. Check the jumper cable connecting
"B1" to "B2" on the back of the ICM.
411 Warning: The antenna cannot find an available service
satellite. You are located outside the coverage area.
412 Warning: The ICM is not receiving the proper DC voltage
from its power supply (this DC voltage must be present to
enable the antenna's AC power circuit). Check the power
cable, then contact KVH.
413 Warning: The antenna is waiting for GPS to acquire a fix.
414 Warning: The antenna is using position data from a backup
GPS device and not its built-in GPS.
417 Warning: The antenna is pointing in a tracking avoidance
zone. Performance might be degraded until the antenna
can switch to an alternate satellite or move outside the
zone.
418 Warning: The ICM is not receiving status information from
the built-in modem. Check the jumper cable connecting
"B1" to "B2" on the back of the ICM.