KVH Industries TracPhone V11 HTS User Manual page 119

No. Description
216 Error: The antenna's cross-azimuth motor or limit switch
failed. Contact KVH.
217 Error: The antenna's skew motor has a power failure.
Contact KVH.
218 Error: The antenna's skew motor or limit switch failed.
Contact KVH.
219 Error: One of the antenna's gyros is out of calibration.
Contact KVH.
220 Warning: The antenna's sensor module failed. Contact
KVH.
221 Error: The system is not receiving any GPS data. Contact
KVH.
222 Warning: The antenna's internal temperature exceeds
acceptable limits. Turn off the system and allow it to cool. If
the problem persists, contact KVH.
223 Warning: The antenna's main board has lost gyro
calibration data. Try recalibrating the gyros (see
"Hardware Restart" on page
calibrate, contact KVH.
224 Warning: The antenna's main board has lost
communications with the LNB. Contact KVH.
225 Warning: The antenna's main board is unable to configure
the LNB. Contact KVH.
231 Error: The antenna's RF software might be corrupted. Try
updating the software (see
page 153).
234 Error: The antenna is not receiving satellite signal strength
(RSSI) data from the ICM. Try these steps:
• Turn the ICM off, then back on.
• Check the wires on the back of the ICM.
• Check the data cable.
235 Error: The antenna has lost RF communications. Contact
KVH.
240 Error: The antenna's C-band LNB is not receiving the
required 10 MHz reference signal from the power/thermal
module. Check the power/thermal module connectors.
TracPhone V11-HTS User's Guide
159). If a gyro fails to
"Software Updates" on
Troubleshooting
125