No Ice Dispensed From Manual Ice Dispense Push Button Switch; Ice Dispensing During Automatic Agitation - Cornelius Enduro ED-250 BCP Installation Manual

T
ROUBLE
NO ICE DISPENSED FROM
MANUAL ICE DISPENSE PUSH-
BUTTON SWITCH
ICE DISPENSING DURING
AUTOMATIC AGITATION
Contact your local syrup or beverage equipment distributor for additional information and troubleshooting
of beverage system.
© 2004-2010, IMI Cornelius Inc.
P C
ROBABLE AUSE
E. Ice chute cover not properly
installed.
F. Defective ice chute interlock
switch.
G. Defective interlock relay.
H. Defective 24V transformer.
I. Defective portion controller.
J. Defective ice gate cylinder.
K. Defective ice gate solenoid
valve.
L. Agitation relay wiring incorrect. L. Red wire should be connected to "+"
M. Defective agitation relay.
N. Defective agitator motor start
capacitor or start relay.
A. Manual/Auto toggle switch in
"Auto" position.
B. Insufficient or no CO2 supply to
dispenser.
C. Defective 24VAC transformer.
D. Defective manual override sole-
noid valve.
E. Defective manual ice dispense
pushbutton switch.
F. Defective agitator motor or start
capacitor or start relay.
G. Defective ice gate cylinder.
A. Manual/Auto toggle switch in
"manual" position.
B. Defective ice gate cylinder.
C. Defective ice gate solenoid
valve.
D. Defective portion controller.
- 14 -
Enduro Ice/beverage Dispenser Installation Manual
E. Make sure that cover is "snapped" into
place.
F. Replace interlock switch.
G. Replace relay.
H. Replace transformer.
I. Replace controller.
J. Replace cylinder.
K. Replace solenoid valve.
terminal (#3) of relay coil.
M. Replace relay.
N. Replace defective component
A. Move toggle switch to "Manual" posi-
tion.
B. Restore CO2 supply to dispenser.
C. Replace Transformer.
D. Replace valve.
E. Replace switch.
F. Replace defective component.
G. Replace cylinder.
A. Move toggle switch to "auto" position.
B. Replace cylinder.
C. Replace valve.
D. Replace controller.
Publication Number: 91971RINS
R
EMEDY