Table of Contents
Advertisement
Basic Operations
Removing Disks
1.
Make sure the optical drive indicator is not lit and press the eject button. The
optical drive tray will pop out.
Make sure the optical drive indicator is not lit before pressing the eject
button.
1
2.
Gently pull out the tray.
3.
Holding its edge, remove the disk from the tray.
4.
Gently push the tray back into the computer.
Do not leave the tray pulled out.
Writing Data to the Disk
You can use CD-R or CD-RW disks to write data. A CD-RW is an erasable disk onto
which you can write data and from which you can erase data. A CD-R is a non-
erasable disk onto which you can write data only once. If free space remains, you can
add data until the disk is full.
• Before writing to disks, follow the instructions below.
• Connect the AC adapter. If the battery is fully discharged, the
• Set the APM button mode to Max Power and set the CPU
• Disable system standby and system hibernate. (See the Power Saving
1-12
writing process will stop and fail.
performance level to 100%. (See the Using the Advanced Power
Management Button section on page 2-9.)
Advertisement
Table of Contents
