IKEA TRIXIG Original Instructions Manual page 11

WARNING! Recharge the battery on a non-flammable surface. Do not recharge
the battery for more than eight hours.
INSTRUCTIONS FOR USE
Using the tool
Note: Sparks may be visible through the slots in the motor housing during operation. The
sparks are a normal reaction of the motor when in use and are created by the components
inside the motor moving against each other. The function of the power tool is not affected
by this. We do however recommend not to use the power tool near any flammable liquids,
gases or dust, which the sparks may ignite.
Keyless chuck
Your drill has a keyless chuck so that you can simply tighten or release screwdriver/drill
bits. Hold the front sleeve and push on the speed control/trigger to open/close the chuck.
Mounting bits and drills
Before any work on the machine (e.g. maintenance, tool change, etc.) as well as during
transport and storage, set rotational direction switch to the centre position. Unintentional
actuation of the trigger can lead to injuries.
Rotate the front sleeve to adjust the chuck until the opening is slightly larger than the
shaft of the screwdriver/drill bit that you wish to use. Insert the screwdriver/drill bit into
the chuck. Tighten the chuck against the screwdriver/drill as described above (Keyless
chuck).
Regulating the shaft speed
It is possible to regulate both shaft speeds from zero to maximum by altering the pressure
applied to the trigger. This enables you to choose the optimum speed for the task you are
working on.
Reversing the direction of rotation
You can reverse the direction of rotation by using the rotational direction switch (4).
To lock the trigger, set the selector to the mid position between the right and left options.
Adjusting the tightening moment
Turn the torque regulator (2) to the desired position. Settings 1-19 are used for tightening/
loosening screws (the higher the value, the greater the tightening moment). Select the
drill symbol before using the tool for drilling.
Magnetic bit holder
You can place the bits and drills you are currently using on the magnetic bit holder (8) on
top of your screwdriver/drill to keep them close at hand while you are working.
LED work light
The screwdriver has a built-in LED work light to illuminate the work area. The LED work
lights up every time the trigger switch is squeezed and then turns off when the trigger
switch is released.
WARNING: RISK OF TRAPPING
Do not hold the front sleeve of the chuck with one hand at the same time as you open or
close the jaws of the chuck with the help of the screwdriver/drill's motor.
Maintenance and cleaning
Keep the screwdriver/drill clean and dry at all times to ensure proper and safe operation.
Wipe off any debris using a soft cloth moistened with water. Do not use any cleaning
agents or solvents.
11