Front Bezel Replacement; Remove The Front Bezel - Lenovo ThinkSystem ST250 V2 Maintenance Manual

Complete the parts replacement. See "Complete the parts replacement" on page 217.

Front bezel replacement

Follow instructions in this section to remove and install the front bezel.

Remove the front bezel

Follow instructions in this section to remove the front bezel.
About this task
To avoid potential danger, read and follow the following safety statements.
• S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off
the electrical current supplied to the device. The device also might have more than one power cord.
To remove all electrical current from the device, ensure that all power cords are disconnected from
the power source.
Attention:
• Read the "Installation guidelines" on page 85 to ensure that you work safely.
• Turn off the server and peripheral devices, and disconnect the power cords and all external cables (see
"Power off the server" on page 13).
• If the server is in a rack, remove it from the rack.
• Remove any locking device that secures the server cover, such as a Kensington lock or a pad lock.
Watch the procedure
A video of this procedure is available at YouTube:
DoEcxrm2zKNpaKOdZ3f8Qc
Procedure
Step 1. Make preparations for this task.
a. Remove the server cover (see "Remove the server cover" on page 199).
b. Remove the front door (see "Remove the front door" on page 124).
Step 2. Remove the front bezel.
a. Lift the three plastic tabs to release left side of the bezel from the chassis.
b. Pivot the bezel as shown to remove it from the chassis.
ThinkSystem ST250 V2 Maintenance Manual
122
https://youtube.com/playlist?list=PLYV5R7hVcs-
.