Front Bezel Replacement; Remove The Front Bezel - Lenovo ThinkSystem ST50 V2 Maintenance Manual

Figure 64. Front fan and rear fan rubber mounts installation
Step 2. Connect the fan cable to the system board, see
After you finish
1. (Removing the front fan only) Reinstall the front bezel, see
2. Proceed to complete the parts replacement, see

Front bezel replacement

Follow this procedure to remove and install the front bezel.

Remove the front bezel

Follow this procedure to remove the front bezel.
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
About this task
Attention:
• Read "Safety inspection checklist" on page iv
work safely.
• Turn off the server and peripheral devices, and disconnect the power cords and all external cables, see
"Power off the server" on page
"Internal cable routing" on page
"Complete the parts replacement" on page
and "Installation guidelines" on page 41
9.
"Install the front bezel" on page
.
Chapter 3 Hardware replacement procedures
19.
85.
158.
to ensure that you
83