Install A Simple-Swap Drive And Drive Cage; (Bay 1-2) - Lenovo ThinkSystem ST50 V2 Setup Manual

Note: The heat sink and processor could be very hot. To avoid burning yourself, wait for a few
minutes after turning off the server before you remove the server cover.
Step 2. Locate the CMOS battery on the system board. See "System board components" on page 18.
Step 3. Gently press on the nub on the side of the CMOS battery as illustrated; then, pivot the battery away
from the seat to remove it.
Attention: Avoid excessive force on the CMOS battery, as it might damage the socket on the
system board and result in system board replacement.
Figure 36. Removing the CMOS battery (CR2032)
After you finish
1. Install a new CMOS battery. See "Install the CMOS battery (CR2032)" on page 89.
Note: Make sure to install the CMOS battery before powering on the server. Otherwise, it might cause
system abnormality.
2. Dispose the CMOS battery as required by local ordinances or regulations.
Install a simple-swap drive and drive cage (bay 1-2)
Follow this procedure to install a simple-swap drive and drive cage into bay 1 or bay 2.
Remove a simple-swap drive (bay 1-2)
Follow this procedure to remove a simple-swap drive from bay 1 or bay 2.
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
About this task
Attention:
.
Chapter 3 Server hardware setup
55